Then everything is broken up into groups. For cymbals I put which position they were in, and if they were left or right panning. So I went through and started labeling all the notes that triggered something, and what it was. The map you can get from ToonTrack is only for EZD, so a LOT of the things that DFH offers (a lot more cymbals, crescendos, etc.) are not on that map, obviously. Speaking of which, I started working on a map for the DFH EZX. This is especially handy when programming by hand or when editing MIDI you've recorded from an e-kit. With a map it is labeled as to what that note triggers. Unless you want to always go "does D2 have a china or a tom flam on it.". About 2 minutes of fiddling around in the menus and I had a fully functioning kit.Īs far as the map just makes everything fall into where it should be, visually. However, the toms were not right, they were triggering cymbals instead of toms so I had to go into the module's settings for all three tom slots and change the note they trigger. I noticed when I first used my e-kit with EZD the ride was triggered by the farthest cymbal pad on the left (normally a crash), so all I did was switch the cables from the pads to the module and that worked. You can set what note the pads are triggering via the module, at least on a DM-5 you can, I've done it.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |